Sign up to remove ads. We'd love to have you amongst our ranks! Just Click here!


gmc forums   gmc forums


Go Back   GMC Forums > GMC Vehicles No Longer In Production > GMC Suburban Forum

Advertisements
cars connected social network






Notices

GMC Suburban Forum Forum for discussions regarding the GMC Suburban


GMC Forum: 1994 K1500 Suburban - Brake Pedal Goes to the Floor
Reply
 
Thread Tools
  #1  
Old 02-10-2018, 07:19 PM
Commander5995 Commander5995 is offline
Junior Member
Drives a GMC K1500 Suburban
 
Join Date: Feb 2018
Location: Ozark Mountains
Posts: 2
Default 1994 K1500 Suburban - Brake Pedal Goes to the Floor

Hey all , been lurking about the site for a bit, thought it was time to join and make it official

I've got a 94' K1500 Suburban that we recently just started driving, and have been working on a number of issues for the past month.

The most needful of which is the brakes. We knew something was wrong with the brakes when we first drove it, it just didn't feel right. Also we noticed shortly later that the brake pedal sunk to far to the floor, and required to much travel and pressure to get the truck to stop.

We found that the front right caliper was froze up, both front brake hoses were going bad, the line that goes to the rear passenger wheel cylinder was rusted through and leaking, and the axle seal on the passenger rear wheel was completely blown and had coated everything inside the drum (including the shoes) with a heavy coat of oil and schmoo, so it obviously had been leaking bad for a while.

So basically the only brake that had been actually working was the front drivers side... oh and someone has screwed with the emergency brake cable and it wasn't working either...

What we have done so far (concerning the brakes at least):

Both new front calipers, new pads, new front brake hoses, replaced one of the rear wheel cylinders, completely cleaned all the oil and schmoo off the entire passenger rear hub, had to pull the right rear axle to replace the bad wheel (axle) oil seal, new rear shoes and springs, and cut out and replaced the bad section of brake line.

Just finished bleeding the brakes today, but the pedal still doesn't feel right.
With the engine off, the pedal is obviously stiffer. But I (being a 6'4" 280lb male) can still push the pedal down at least near the floor. With the engine running, the pedal goes very easily all the way to the floor.

I'm thinking its the master cylinder. As the brake booster seems to be ok.
I'm really REALLY hoping that it is not the ABS "pump"? module? or whatever you want to call it.

One question I have about the ABS is how do you bleed it? And would it even need it??? If it does need bled, could this be causing the issue??

Any Input would be Much Appreciated!

Last edited by Commander5995; 02-10-2018 at 07:25 PM.
Reply With Quote

  #2  
Old 06-28-2018, 03:40 PM
grouchyoldbiker grouchyoldbiker is offline
Junior Member
Drives a 1998 GMC Suburban
 
Join Date: Jun 2018
Location: Pennsylvania
Posts: 1
Default

I'm a new kid on the block (forum) but have a fair amount of experience repairing my own vehicles. First, make sure all the bleeder nipples are facing down. If it is facing up you'll get an air bubble in the caliper and never get them bled properly. Had that problem when I bought a caliper for my Jimmy. Right part number on the box, but wrong caliper. It bolted up no problem, but peddle was extremely soft.

Unless the peddle is pulsing when you step on the brakes you can pretty much count out the ABS module. Had that problem on my Jimmy too.
Also use a flashlight and look under the dash where the brake booster bolts to the firewall. Sometimes they will leak on the inside but you won't know it looking at it under the hood. Good Luck...
Reply With Quote
Reply
Registered members see less ads. Please sign up! We'd love to have you...

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:04 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
gmcowners.com recognizes that "GMC", it's logos and various model names and numbers are registered trademarks of the General Motors Corporation. These terms are used for identification purposes only. gmcowners.com is not affiliated in any way with the General Motors Corporation, GMC or any other company listed herein. All information on this site is the opinion of its members and not the opinion of the site itself. ©2017 Madison Ross Media Group. All rights reserved. Content published on GMCOwners.com requires permission for reprint.


MADISON ROSS MEDIA GROUP MARKETPLACE
Need products for your GMC Truck? Check out your options at the links below:

Looking for something a little sporty? Believe it or not, Kia may have something for you. The Kia Stinger is a large sport-oriented hatchback sedan in the mold of the Audi A7.