2013 Leveling Kit

B

badazz2013

New member
Joined
Nov 20, 2013
Messages
6
Reaction score
0
Points
0
Location
Fort Walton Beach Florida
What up fellow forum followers,

I just have a quick question for you. I have a 2013 GMC Sierra Quadcab 1500 4x4 and I am looking at getting a leveling kit but don't know which one to get. so I figured I would ask the crowd if anyone has had experience with purchasing these and had any recommendations. Any input is greatly appreciated and I look forward to future posts.

-Badazz
 
Hey, not sure if you received any feedback on your question, but I recently purchased a Summit Engineering 2" leveling kit off Ebay for $39.99 and I am extremely happy with it. All I did was unbolt the two bottom strut bolts, loosen the sway bar end link, then used some muscle and the spacer slid right in. I took it to the alignment shop and voila... done!

It's similar to the rough country spacer, but it is billet aluminum, and $20.00 cheaper!
 
I have a 2010 Sierra Quad cab 4x4 and I installed the 2 inch Rough Country levelling kit. Easily installed under strut and the truck sits nice and level now. Front end aligned and your ready to go.
 
I have the 2 inch Rough Country levelling kit on my 2010 GMC Sierra Quad cab 4x4. Easy install and the truck sits nice and level.
 
so I have read your posts and a couple of other post on other sites and they have mentioned a Rough Country leveling Kit. I guess the next "noob" question is, how do you know which size to get?
 
I have a 2011 sle and i installed a procomp 2.25 inch leveling kit and i installed it in about 2.5 hours in the garage. it was really easy.
 
hey guys, i noticed everyone is going 2-3" levelling kits, what size tires do you run?
 
Rough country or pro comp .i noticed that the rough country come in aluminum and steel not so sure as to which one ?boy do I need help here ? Am so lost wanna do it. It is a 2012 sierra would like to make it look a lil bit beefier but not totally over kill something that gives it a lil more height ...what could I do as for tires later was looking at bf's for it how big can I go? Thanks guys in advance ...
 
i am looking at doing a 2.5 rough country with my stock 20's for now. when I need replacement tires, I plan on going with the Nitro Trail Grapplers but that wont be for a while because my truck is only a year old and only has like 8500 miles on it.
 
The aluminum one is for aluminum lower a arms, and steel is for steel lower a arms
I believe if I read there add correct
I used Fabtech upper spacer and it raised it 2"
I put on some 33 12.50 17" tires on and have plenty of clearance
 
lift/leveling

Have a 2010 Sierra SLT MAX
I did the rough country 3-1/2" lift/leveling kit (3-1/2" front - 1-1/2" rear) and
think it looks great. Put on 285 BF Goodrich Mud Terrain KM2's.
 
You must log in or register to reply here.

Share this page



Back
Top