2000 SIerra 4.3 v6 spark plug wires...

[markophonic]

I want to replace the spark plug wires and plugs.

I think that I'm going to get AC Delco 41-932 plugs.

What should I get for wires...I see them anywhere from $21.99 to over $100.00?

 

[Molson02536]

I want to replace the spark plug wires and plugs.

I think that I'm going to get AC Delco 41-932 plugs.

What should I get for wires...I see them anywhere from $21.99 to over $100.00?

Stay with the stock AC Delco OEM or go with http://www.accel-ignition.com/Produ...onName=Select+Aspiration&brandName=All+Brands

Good luck and hope this helps.

 

[markophonic]

Thanks Molson!

I tried responding to my previous post about the P0305 misfire code I was getting but the post doesn't show up???

anyhow I took it to a indy shop near my home and they ran their computer diagnostic tests etc. obviously cam e up with the misfire code. They pulled the spark plug and said it was "really wet". It was a Bosch platinum and he said those don't work so well in this motor. replaced it with an AC Delco and now it runs fine. I only drove a few miles home but it ran great and no rough running misfires. I bought the Accel cap and rotor that you suggested to me and I want to replace the remainder of the plugs and the wires.

I cleaned the MAF sensor with CRC MAF cleaner, put some seafoam in the gas tank and will pour some in the pcv vacuum line. I did shoot some in the throttle body, let it sit, start it up and run it out.

Thanks for all of your help!!

 

[markophonic]

thanks

Thanks Molson!

I tried responding to my previous post about the P0305 misfire code I was getting but the post doesn't show up???

anyhow I took it to a indy shop near my home and they ran their computer diagnostic tests etc. obviously cam e up with the misfire code. They pulled the spark plug and said it was "really wet". It was a Bosch platinum and he said those don't work so well in this motor. replaced it with an AC Delco and now it runs fine. I only drove a few miles home but it ran great and no rough running misfires. I bought the Accel cap and rotor that you suggested to me and I want to replace the remainder of the plugs and the wires.

I cleaned the MAF sensor with CRC MAF cleaner, put some seafoam in the gas tank and will pour some in the pcv vacuum line. I did shoot some in the throttle body, let it sit, start it up and run it out.

Thanks for all of your help!!