95 5.7 tbi no spark, no fuel--help

[hydro]

Truck has 62K on it and the last time I started and ran a month ago everything was great, 2 weeks ago went to drive and cranks great but no start, thought maybe fuel pump, squirted gas in TB, nothing, pulled plug checked for spark, nothing, so this is what I have done, replaced coil, ignition control module, coolant temp sensor, cap & rotor, fuel pump relay, NOTHING but crank and no start, I have hooked up an inductive timing light to a plug wire and had no light when cranking also the tach does not move when cranking, Soooooooo....... have been looking on the internet and also at the library and everything points to the crankshaft position sensor, so bought one, NAPA pt.# CSS119, I can't find the right information where this is located on my truck, everytime I find the location on the net or in tech. information at the library it is not located either or!!
All tech information points to the crank sensor stating that it triggers both the coil and the fuel injectors.
Can anyone give me some difinitive information to get this thing running again???
Thanks for any input.

 

[98trck]

on my '98 the crank sensor is behind the harmonic balancer there is two wires that went to it I don't know if you have two pull harmonic balancer to replace it but it sure looked like it did
I know you have but have you done the normal trouble shooting steps
check fuses, remove the fuse and check it also removing the fuse and putting it back in may make a better connection
do you remember if you used too hear the fuel pump when you turned the key on if you did and now you don't it may be the relay or the fuel pump -note when you go to buy a new relay look at the diagram on the side of the relay make sure they are the same I have seen more than one miss packaged, on my '98 I had a problem with the two or three(I don't remember ) wire plug at the distributor
the parts you have replaced did you use 'new or known good used pieces'