FCC ID # for 2001 GMC Sierra?

Russell_N

New member
Joined
Apr 21, 2010
Messages
1
Reaction score
0
Points
0
i'm trying to order a new Keyless Entry remote for my truck but it says i need to know the FCC ID number and i don't know how to find it,
 
i'm trying to order a new Keyless Entry remote for my truck but it says i need to know the FCC ID number and i don't know how to find it,


Replacement OEM Remote Keyless Entry Fob for a 2001 GMC Sierra 1500. FCC ID: KOBLEAR1XT.

Replacement OEM Remote Keyless Entry Fob for a 2001 GMC Sierra 2500. FCC ID: KOBLEAR1XT.

Replacement OEM Remote Keyless Entry Fob for a 2001 GMC Sierra 3500. FCC ID: KOBLEAR1XT

Program instruction:

1. Close all doors

2. Insert key into ignition

3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.

4. Perform steps 5 through 8 in a fairly rapid succession.

5. Turn the ignition to the ON position (as far as you can go without starting the engine.)

6. Turn the ignition to the OFF position.

7. Turn the ignition to the ON position (as far as you can go without starting the engine.)

8. Turn the ignition to the OFF position.

9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.

10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.

11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).

12. Turn the ignition to the ON position to exit the programming mode.

13. Test remote(s).

Good luck :D
 
Thanks for the information. I just wish my Saab remotes were as easy to program... Ron
 


Back
Top