This problem started about a week ago. When i am coming to a stop my ABS apply just before i stop. I checked all my disks and pads and they are all fine. I also checked my ABS sensors in the front tires (Both read 1003ohms).
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
GMC Sierra ABS brakes applying at slow speeds?
- Thread starter Tarkanis
- Start date
happy 2011
New member
ok not a big deal here is what you do.
Remove front rotors (mark rotors so they go back on hub same way)
remove sensors from wheel bearings( Older models require removing 2 wheel bearing bolts)
Take a file and file down where the sensor mounts to the bearing asy.(what happens is rust lifts the sensor up a slight bit and caues a open speed at 5 mph or less makes abs come on)
Clean sensor and lube reinstall road test Don't be shy about using the file eather.
Only replace the sensors if they break while removing from hubs (1 in a hundred break) Good luck
Remove front rotors (mark rotors so they go back on hub same way)
remove sensors from wheel bearings( Older models require removing 2 wheel bearing bolts)
Take a file and file down where the sensor mounts to the bearing asy.(what happens is rust lifts the sensor up a slight bit and caues a open speed at 5 mph or less makes abs come on)
Clean sensor and lube reinstall road test Don't be shy about using the file eather.
Only replace the sensors if they break while removing from hubs (1 in a hundred break) Good luck
knucklehead27
Member
- Joined
- Jan 14, 2011
- Messages
- 50
- Reaction score
- 0
- Points
- 6
what year vehicle? there's a recall on some models for abs activating at low speeds, i believe at 4 or 6mph but dont quote me on that.