In process of replacing injector and nut kit. It is a mess in there...must have been leaking for a long time and there is a lot of crusted up carbon and whatnot everywhere. Cleaning it up ad best as I can. Took poppets out and there is also a lot of this stuff in each of the six ports. Trying to carefully remove this but I know some in flaking off and falling into the portals. Can I spray something like Deep Creep in there to clean them out? Any ideas welcome. Thanks.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
spider injector removal questions
- Thread starter threecar
- Start date
Yeah I have used the shop vac. Just wondering if I can spray the Deep Creep right into the injector ports. I would guess I can considering you can put seafoam in gas, crankcase, and brake booster line. Just want to be sure.
greg409
New member
x2 on the hydrolock, but that's a bunch of fluid.
When I did mine a month ago, I had a small (1/2") round brush that I kept dipping in gas.
The intake gets so filthy since the egr dumps in there
the gas will evap off fairly quick
I think in retrospect, I'm going to seafoam mine a couple of times, tho' I don't know if the layer of poo is really hurting anything (it's got 142k on it)
luck,greg
When I did mine a month ago, I had a small (1/2") round brush that I kept dipping in gas.
The intake gets so filthy since the egr dumps in there
the gas will evap off fairly quick
I think in retrospect, I'm going to seafoam mine a couple of times, tho' I don't know if the layer of poo is really hurting anything (it's got 142k on it)
luck,greg
Last edited: