2.03.14
I had recently found that my Oil was very much diluted / thinned by the
addition of Gas into the Oil.
I know that this excess Gas in the Oil was created while troubleshooting
a faulty MPI Fuel Injection Spider assembly where I could see excess fuel
in the MPI cover intake unit. In addtion, after this spider troubleshooting repair - I was experiencing Starter / Battery issues where I was cranking the engine with a No Start Condition continuously. This added to the diluted oil - "Flooded" the system ,as well.
Fortunate - I discovered this diluted Oil rather quickly - had only put
about 1 1/2 hours total of run time at idle and 2000 rpm while vehicle was parked with this diluted oil.
Question :
What wear did the engine experience during this time of diluted oil
( felt like water ) Bearings , Piston Rings , Cylinders Scored , etc.
I had recently found that my Oil was very much diluted / thinned by the
addition of Gas into the Oil.
I know that this excess Gas in the Oil was created while troubleshooting
a faulty MPI Fuel Injection Spider assembly where I could see excess fuel
in the MPI cover intake unit. In addtion, after this spider troubleshooting repair - I was experiencing Starter / Battery issues where I was cranking the engine with a No Start Condition continuously. This added to the diluted oil - "Flooded" the system ,as well.
Fortunate - I discovered this diluted Oil rather quickly - had only put
about 1 1/2 hours total of run time at idle and 2000 rpm while vehicle was parked with this diluted oil.
Question :
What wear did the engine experience during this time of diluted oil
( felt like water ) Bearings , Piston Rings , Cylinders Scored , etc.